Houdini 27 Harness

Designed for single or split backed double seats

This is a vehicle positioning harness for children and adults with special needs such as Autism Spectrum Disorder (ASD), Attention Deficit Hyperactivity Disorder (ADHD), Down Syndrome, Asperger’s disorder, developmental delay or other challenging behavioural needs where the person has problems with attention and safety. Providing safer travel and management of these loved ones when travelling in the car or other means of transport.

Alternatively, this harness can also be used to offer postural support and assist in seating the occupant in an upright sitting position for persons with physical disabilities such as Cerebral Palsy (CP) and other significant physical disabilities or complex needs where extra support and positioning is required during travel.

Fits most types of vehicle seating including low or high backed, and is used on aircraft seats by many leading airlines. The two transverse fixing straps do not interfere with the passenger behind using the drop down trays (depending on airline). It is recommended to seek permission from the airlines to use the Houdini 27 harness prior to departure.

The harness consists of a full body 5-point harness connected to a back pad which is fitted horizontally around the vehicle seat back with two horizontal fixing straps.

The Houdini 27 harness is identical to the Houdini 28 harness, except the mounting straps are different for different seats.

Please note, to comply with safety regulations, the vehicle safety belt must always be worn over the top of the harness. The combination of the existing vehicle safety belt and the secondary harness offers added security for the passenger.

It is advisable to carry out a safety and risk assessment to first consider the problems involved and what the situation would be if the passenger is not wearing a special needs harness. Could they be in danger to themselves and to other passengers in the vehicle or even other drivers on the road if they are not safely seated during travel?

A safety webbing slicer is included with every vehicle harness and must be kept in the vehicle as a safety precaution.

Checklist:

Only suitable for single backrest seats eg: front vehicle seat, split rear backrest seats, bus and airline seats
Attaching straps go horizontally around the rear of the seat it is installed on
Full 5-point harness for good support (crotch strap between the legs doesn't need to be used if not required)
Access to rear of seat is necessary when installing
Cross strap can be purchased for additional security of the shoulder straps (prevents the shoulder straps been pulled off)
No gap required between seat and backrest

Order Now

Need assistance with comparing vehicle harnesses? View Houdini Vehicle Harnesses: What to Consider and What Are the Options?

Media

Houdini Vehicle Harnesses: What to Consider and What Are the Options?

How to Install Houdini 27 Harness

Downloads:

Houdini Harness Flyer

Comparison Chart (AU) - Vehicle Harnesses

Comparison Chart (NZ) - Vehicle Harnesses

User Manuals:

Houdini Harness Model 27 User Manual

Accessories

Houdini Harness Cross Strap

Read more

Houdini Harness Cross Strap

A Cross strap can be fitted to this harness to hold the shoulder straps together and prevent them from slipping off.

! WARNING: May Present Hazard

The Harness Cross Strap should only be used if required to prevent shoulder straps falling down, or as a restraint mechanism when a user is escaping from their harness.

Potential risk of injury increases due to the device’s proximity to the neck area.

Please ensure that the cross strap is located far enough down to be safe for the user.

Cross Straps must not be used on Harnesses with Chest Pads as the Cross Strap would be too near to the neck.

Side-Release Buckle 4604-3112-019

Anti-Escape Buckle 4604-3004-026

Pen/Key Release Buckle 4604-3004-025

Side-Release: 4604-3112-019, Anti-Escape: 4604-3004-026, Pen/Key Release: 4604-3004-025
Houdini Harness Anti-Escape Buckle

Read more

Houdini Harness Anti-Escape Buckle

Steel anti-escape buckles can be installed to prevent children with inquisitive fingers, challenging behaviour or learning difficulties escaping from the carseat or harness during travel. These unique buckles have proven very successful as they operate in reverse to a normal buckle.

To disengage, you raise the spring-loaded catch, and then tension the belt before it will release. (It will not press release)

Side-Release Buckle	4604-3112-019
Anti-Escape Buckle	4604-3004-026
Pen/Key Release Buckle	4604-3004-025

Houdini Harness Pen-Release Buckle Upgrade

Code	Model	Description
4604-1305-031	Model 13	Upgrade on 2 waist band buckles and neck strap (total 3 buckles)
4604-2215-031	Model 22	Upgrade on crotch strap, upper neck strap and 2 waist band buckles (total 4 buckles)
4604-2222-031	Model 22	Extra fixing strap upgrade for when Model 22 is upgraded
4604-2805-031	Model 27 or 28	Upgrade on waist belt
4604-3105-031	Model 31	Upgrade on two waist buckles (total of 2 buckles) and includes release tool.

Code	Size	Age Group	Buckle Type
#4604-2702-017	27A	Paediatric	Standard centre-release buckle
#4604-2702-026	27ASB	Paediatric	Anti-escape buckle
#4604-2703-017	27B	7 years to Adult	Standard centre-release buckle
#4604-2703-026	27BSB	7 years to Adult	Anti-escape buckle

For consideration once child is of an appropriate height and weight to progress from a full booster into a half booster, usually around 6 or 7 years of age. If unsure please contact one of our product consultants.

Washing instructions

Hand wash only - in warm water up to 70/80 degrees.
Use mild detergent/anti-bacterial liquid wash.
Mild disinfectant can be used.
Do not use bleach
Do not tumble dry

Warranty:

12 months

FAQ

Does this harness require a vehicle tether point?

No. This harness does not require any tethering; it is not a safety harness. It is simply attached to the vehicle seat with the securing straps.

If I can't pass the strap between the seat and the backrest, what can I do?

This can be common. Most vehicles have a carpet flap at the rear which prevents the straps coming vertically around the seat. In virtually all cases the carpet can be cut with a pair of scissors or a knife to provide access through.

How do I Care for my Harness when it needs washing?

Harnesses must be cleaned by Hand washing only, in warm water up to 70 or 80 degrees.
Use a mild detergent/anti-bacterial liquid wash.
Mild disinfectant can be used.
Do not use Bleach or Tumble Dry your harness.